Mitsubishi MOTION CONTROLLERS Q173DCPU Manuál s instrukcemi stáhnout pdf (Strana 123)

2 - 94

2 SYSTEM CONFIGURATION

(4) Setting of the axis No. and axis select rotary switch of servo

amplifier

Axis No. is used to set the axis numbers of servo amplifiers connected to

SSCNET

connector(CN ) in the program.

The following range can be set in the Motion CPU module.

Axis No. is set for each SSCNET

(/H) line in the system setting of

MT Developer2. Axis No. is allocated and set for the setting axis number (d01 to

d16) of servo amplifier.

Axis No. setting range

Q173DSCPU

1 to 32

Q173DCPU(-S1)

Q172DSCPU 1 to 16

Q172DCPU(-S1) 1 to 8

Since the axis number (d01 to d16) of servo amplifier on the system setting

screen corresponds to axis select rotary switch (0 to F) of servo amplifier, set the

axis select switch referring to the table of next page.

•

Setting display of axis No.

Set the axis No. relative to axis number (dno.).

• Axis select rotary switch

(Servo amplifier)

(Note): Correspondence between dno. and axis select rotary switch of servo amplifiers is shown in

the next page.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 251 252

Žádné komentáře

Mitsubishi MOTION CONTROLLERS Q173DCPU Manuál s instrukcemi Strana 123