Mitsubishi MOTION CONTROLLERS Q173DCPU Manuál s instrukcemi stáhnout pdf (Strana 61)

2 - 32

2 SYSTEM CONFIGURATION

POINTS

(1) Be sure to turn OFF the Multiple CPU system's power supply before the rotary

switch setting change.

(2) It is recommended to shift to the mode operated by ROM after the programs

and parameters are fixed. The erasing of the programs and parameters can

be avoided even if the battery decrease. (The ROM writing cannot be

executed for the current position of the servo motor in the absolute position

system, home position and latch device. Back up them beforehand using

MT Developer2.)

Refer to Section 4.4 of the "Q173D(S)CPU/Q172D(S)CPU Motion controller

Programming Manual (COMMON)" for details of the ROM operation.

7-segment LED Operation overview

Disconnect

Connect

(10Mbps)

Connect

(100Mbps)

Full duplex

Half duplex

IP address

(Note)

(ex. 192.168.3.39)

Subnet mask pattern

(Note)

(ex. 255.255.255.0)

Default router IP

address

(Note)

(ex. 192.168.3.1)

Link status

(Note): When the Ethernet parameters are not written in the Motion CPU, the addresses are

displayed as follows.

• IP address : 192.168.3.39

• Subnet mask pattern : 255.255.255.0

• Default router IP address : 192.168.3.1

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 251 252

Žádné komentáře

Mitsubishi MOTION CONTROLLERS Q173DCPU Manuál s instrukcemi Strana 61