Mitsubishi MOTION CONTROLLERS Q172DCPU Manuál s instrukcemi stáhnout pdf (Strana 211)

8 - 26

8 OUTPUT MODULE

(1) Cam No.

This device is used to set the number allocated in created cam data.

The number of cam data is set "1 to 64" for each machine.

A cam No. is used with the number which offset value attached by the machine

name sequence registered on mechanical system editing screen in the

mechanical system program.

Machine name sequence Setting cam No.

1 1 to 64

2 101 to 164

3 201 to 264

4 301 to 364

(2) Resolution

(a) This device is used to set the number of index divisions in one cam cycle.

(b) The following conditions need to be satisfied in order to output the all point

data of resolution correctly.

• Number of pulses per cam revolution (Nc)

Resolution

• Time required per cam revolution

Operation cycle × Resolution

(3) Stroke amount/cam No. change point

(a) This device is used to set a position at which the stroke amount/cam No. is

switched during operation.

(b) When the set switching position [range: 0 to (resolution -1)] is reached, if the

stroke amount/cam No. is normal, it is switched to the setting stroke amount

and cam No.

(4) Operation mode

(a) This device is used to set the two-way cam mode/feed cam mode.

1) Two-way cam mode ....... A two-way operation is repeated between the

lower stroke limit value (lower dead point) and

the range set in the stroke amount.

Stroke amount

Lower stroke limit value

(Lower dead point)

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 315 316

Žádné komentáře

Mitsubishi MOTION CONTROLLERS Q172DCPU Manuál s instrukcemi Strana 211