Mitsubishi MOTION CONTROLLERS Q172DCPU Manuál s instrukcemi Strana 157

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 316
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 156
7 - 10
7 TRANSMISSION MODULE
d) If input to clutch (travel value after the main shaft's differential gear)
changes after smoothing completion, the smoothing processing is not
executed and output directly.
Input to clutch
Internal clutch status
Clutch status signal
Travel value after
the main shaft's
differential gear
Output to output axis
by the smoothing clutch
for linear acceleration/
deceleration system
V
V
t
t
Slippage [PLS]
Smoothing completion
Smoothing processing
is not executed.
Smoothing completion
Slippage [PLS]
e) The smoothing clutch complete signal turns ON after completion of
smoothing processing.
• ON
…."(Remainder slippage) < (Slippage in-position range)"
• OFF… Smoothing processing start (Clutch ON/OFF)
The smoothing clutch complete signal is used to check the completion of
smoothing processing, etc.
Zobrazit stránku 156
1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 315 316

Komentáře k této Příručce

Žádné komentáře