Mitsubishi RS232/485/LAN Serial Communication Control Manuál Strana 201

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 349
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 200
9 JTEKT(Toyoda)
2-201
Chap.2
Connection Diagram 9-2: TOYOPUC-PC3JG (Built-in Link) - MICRO/I
PLC(RS-485/422) HG1F/2F/2S/3F/4F(RS-485/422)
Pin No.
Pin No.
Name
Name
HG1F
Connector
HG1F
Terminal
HG2F/
3F/4F
HG2S
G FG Cover - 1 1
L(+) TERM - - 9 -
L(-) RDA(RD+) 2 3 10 32
0V RDB(RD-) 7 4 16 33
SDA(SD+) 1 1 11 30
SDB(SD-) 6 2 15 31
CS- 9 - 18 37
RS- 8 - 19 35
CS+ 4 - 21 36
RS+ 3 - 22 34
SG 5 5 7 29
Internal
termination
resistor
330-Ohm
D-sub, 9P connector socket type (HG1F)
D-sub, 25P connector socket type (HG2F/3F/4F)
D-sub, 37P connector plug type (HG2S)
Screw Terminal
Double Shield
- There is no pin No. corresponding to TERM on the HG1F/HG2S. When inserting a
termination resistor, use a communication switch. For the setting of the switch, refer to "3
Important Points Regarding Wiring" in Chapter 1.
When you use the Terminal Block type of HG1F, make sure to configure the Hardware Flow
control to NONE because the HG1F doesn’t have control lines.
Zobrazit stránku 200
1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 348 349

Komentáře k této Příručce

Žádné komentáře